Can't change Current Tool #

[sjm1340]

Currently running:
Mach: 3.043.037
MSM: 2.0
Windows: XP
Controller: SmoothStepper
Plugins: SmoothStepper, ShuttlePro

I can't seem to change the Current Tool #. If I put "T1M6" in the MDI the Next Tool# changes to"1" but the current tool stays at "0". If I put in "T4M6" in the MDI the Next Tool# changes to "4" but the current tool stays at "0".

This problem occoured after I went to the updated version of Mach and MSM. I had been using the previous versions for several months without an issue.

Thanks,

Scott

[DaveCVI]

I have noticed that I've had several people report lately that later versions of mach seem to reset the tool change mode when they install -

Please go to mach's menus and use config/general config and check the Tool Change mode - it sounds like mach is set to "ignore tool change" mode. That would match the symptom of mach doing the T# but not the M6.

Dave

[sjm1340]

Thanks Dave!

That did the trick. I would have never thought to look there.

Scott

[DaveCVI]

Cool - one problem fixed.
Dave