touch probe setup macro

[stephenmhall]

I was recently getting my probe centred by moving round in 120deg steps adjusting the 3 screws to move it zeroing it against an edge then spinning it 180deg and probe only move to test diffence and adjusting to zero, I wondered if you could add a probe option to test to 6 points within a circle and display a plus error on 3 of the points. A simple jig with a circular pocket and a centre hole could be used to align the spindle to known centre before swapping in probe for setup.

Attachments:

[DaveCVI]

Thanks for the suggestion. I have looked at adding some support to make centering a probe easier. This is currently on the "percolating list".
Right now I'm focused on getting MSM 2.0 out - the software is in good shape, now I need to get time to do some web site revamping for 2.0.

Dave