|
Post by DaveCVI on Mar 24, 2012 20:11:30 GMT -8
Hi, A couple of introduction videos that show the basic operation of MSM Turn and Mill-Turn are now available. There is also a video which demonstrates the Mill-Turn use of probing while in Mach's Lathe mode to find & setup XY offsets for Center tools. Go to the CVI web site, video page www.calypsoventures.com/machstdmill/videos.htmland scroll to the bottom to find the new Turn Videos. Dave
|
|
|
Post by woffler on Mar 26, 2012 17:29:38 GMT -8
I would like to see a video of Mill -Turn actually making something.
|
|
|
Post by DaveCVI on Mar 26, 2012 18:48:52 GMT -8
Hi, A reasonable desire - It really does work - honest! For example the picture of the chess piece in the mill turn manual was taken after I had turned that on my mill. Seriously, I intend to make some more videos as soon as I can. I had wanted to make more videos before releasing the beta, but I broke the headset that I use to make the videos this weekend and that put a stop to my movie director career for a bit. I decided not to delay the release until after I made more videos. My schedule has been very busy lately and I am having trouble finding the extra time videos require (you'd think they are quick to make, but they aren't - and every time I play one back to check it, I threaten to erase it instead of posting it as they can always be improved). Dave
|
|
|
Post by DaveCVI on Mar 28, 2012 17:15:36 GMT -8
Hi, 5 more videos posted for mil-turn including one showing a chess piece being cut on a mill.
Dave
|
|