|
Post by mikefrancies on Nov 30, 2010 1:46:52 GMT -8
Hi, I like the look of the new screens but have not yet had a chance to run the machine with them yet - too many jobs on at the moment to try anything new However, playing without a machine attached, I noticed something that I would find problematic when actually machining. I often use 'FRO' (Feed Rate Override) and find the slider very useful, rather than having to type in a percentage. Also I think a 'Reset' button is needed for those times in a program when you no longer need the override. It is very quick to hit a 'Reset' button and a lot slower to have to type '100%' in the field. Just my twopenny worth. (or two cents) ;D All the best, Mike
|
|
|
Post by DaveCVI on Nov 30, 2010 8:51:30 GMT -8
Hi Mike, I'll have to refund your twopenny worth Hit tab to get the fly out page - on it are the controls you want. The fly out page is avail from any other page so the override controls are always accessible no matter what page you are on in MSM. If you run the 12x9 resolution screens the override controls (and resets) are also avail on the main run page. Dave
|
|
|
Post by mikefrancies on Dec 1, 2010 13:49:07 GMT -8
Thanks Dave. I thought it must have been too obvious to miss out. Passed me by though Mike
|
|