|
|
Post by woffler on Sept 5, 2011 13:06:31 GMT -8
I have installed it Say's it is licensed ,i get pin out lighting up in software on hardware page but no x,y, z, or spindle movement any one have any ideas? if i go back to my old profile everything works does this thing require a charge pump signal?
|
|
|
|
Post by woffler on Sept 5, 2011 17:46:49 GMT -8
Forgot some info:mach version R3 043.037 current version machstd mill ,Running windows XP ,Shuttle pro plug in installed .Servo system with Vfd pwm spindle control
|
|
|
|
Post by DaveCVI on Sept 6, 2011 7:45:42 GMT -8
Hi,
It sounds as if the profile you are using for MSM does not have all your machine settings int it.
When you created the profile for use with MSM, which option in section 3.2.10 of the MSM readme file did you use?
I'd guess that maybe you used 3.2.10.1 but then did not add all the machines settings to that profile. If so, given that you have a working hardware profile for the machine, you may want to follow the steps in 3.2.10 again but start by cloning the working profile to create you MSM profile.
re charge pump question: MSM does not know or care about the charge pump - that's a hardware topic and is or is not required based on how your control is set up.
Dave
|
|
|
|
Post by woffler on Sept 6, 2011 15:49:47 GMT -8
That is what i wound up doing was clone from my original xml file. and then loading your set file .I did clone from your std mill file and entered all new xml info but it just would not function why i have no idea i went over the setting several times so i gave up on it. Any way i got it to work with my xml.
|
|
|
|
Post by DaveCVI on Sept 6, 2011 21:01:17 GMT -8
OK, good to know you have it sorted out.
Dave
|
|
