|
|
Post by chrisattebery on Dec 17, 2012 10:47:36 GMT -8
Hello,
I just installed MSM on my machine. Now I'm trying to figure out how to copy all of my Mach3 Mill settings to the MSM Mill config. Is there a simple way to do this?
Thanks,
Chris
|
|
|
|
Post by DaveCVI on Dec 17, 2012 11:37:09 GMT -8
Hi,
How did you set up a profile for use with MSM?
If you followed the instructions in the MSM readme file, you should already have the settings in the MSM profile.
Even if you did not follow the MSM readme instructions, you can still use them to make a MSM profile with all the machine settings - please see section 3.2.11 of the readme file; it tells you how to clone an existing machine profile and use the cloned copy for MSM.
FYI - with MSM installed, the readme can be found at
C:\Mach3\Documentation\MachStdMill\MachStdMill README.pdf
Dave
|
|
|
|
Post by chrisattebery on Dec 17, 2012 12:03:39 GMT -8
Hi Dave, No.  I ran the installer and then read the manual after I realized that I must have missed it. Too many years of installing Windows programs had me trained (slightly spoiled) that all I had to do was run the installer and click "Next" a few times. I just read the README and the procedure is clear enough. I'll give it a shot tonight when I get home. Thanks for your patience, Chris |
|
|
|
Post by DaveCVI on Dec 17, 2012 12:41:18 GMT -8
Chris, He he, no problem - ;D I've been known to skip reading the instructions once or twice myself  Let me know if you need any additional assistance. Dave |
|
I ran the installer and then read the manual after I realized that I must have missed it. Too many years of installing Windows programs had me trained (slightly spoiled) that all I had to do was run the installer and click "Next" a few times. 