|
Post by plungerhead on Jun 13, 2012 19:36:07 GMT -8
Dave,
Info: Mach vers .62 LMS 3505 (Seig KX3) Win 7 32 bit, parallel
Downloaded MSM 2.0 tonight (twice, once after re downloading Mach.62) but could not find mill-turn. Lathe extension was checked on the download. Suggestions?
Thanks, Brad Barron
|
|
|
Post by DaveCVI on Jun 13, 2012 22:08:55 GMT -8
Are you downloading the Personal edition or the Professional Edition? Mill-Turn is part of PRO but not Personal.
Then when you run the Pro installer, Mill-turn has to be selected for installation. Mill-Turn is an option under lathe support. It is selected for Full installs or by the user for a custom install.
Dave
|
|
|
Post by plungerhead on Jun 14, 2012 18:51:19 GMT -8
I had just renewed for Pro (previously expired 4/7/2012), waited several minutes until my payment was recognized, then proceeded to download. However, I just figured out the problem. After creating the new profile, I was loading the wrong screen set. I finally loaded lathe1set and all is good. Sorry for any trouble.
Thanks,
Plungerhead
|
|
|
Post by DaveCVI on Jun 14, 2012 19:28:31 GMT -8
Food to know you got it going.
BTW, I've had several people tell me that they were looking for Mill-Turn to show up with the mill profile.... after all it does run on a mill.... but since it's late support for the mill, it requires a lathe profile. I've added a note about this to the manuals, so this will be part of the instruction the next time the manuals get released.
Dave
|
|